Better way to clean impactor pin
Hi everyone,
The impactor pin on my unispray source (Xevo-TQ-XS) is quite dirty. I am usually cleaning it with a wipe saturated with IPA/Methanol as advised by engineers.
Is there a more efficient way to clean it without damaging the part?
Thank you,
Clem
The impactor pin on my unispray source (Xevo-TQ-XS) is quite dirty. I am usually cleaning it with a wipe saturated with IPA/Methanol as advised by engineers.
Is there a more efficient way to clean it without damaging the part?
Thank you,
Clem
0
Best Answer
-
Following this: further instructions says that one can clean the impactor pin with some laping film before wiping with methanol.0