Start p/v function, cant find it on report!
I have a test where I need to measure the p/v value of a particular peak and although I can see it in my reviewed result set I cant seem to add this value in my report method. I can see end p/v but not start p/v, and ive checked both peak and sys suit peak categories in the report editor? Any idea what may be going on here? Do I need a specific table for this- im using "All Peaks" table.
0
Answers
-
Sometimes end p/v is the only data available and it is display under system suitability section.
I would double check if the review where you see both start and end, is the same review which you use to process the sample set but after that I'm out of ideas.0
