Can you display raw data (acquired) points in a chromatogram ?
I can only tabulate points across peak or 'enable tick marks' (not entirely sure what this is for) but not show data points on baseline plot
Currently most our LC's are default with 'Peak width : >0.1min (2 s resp time (5Hz)), though I am struggling to see how 'enable tick marks' shows these individual points and corresponds to points across peak (assuming increments in this case 0.20 seconds?)
Ok ,, not what I expected
Would be nice to actually see where data points are collected for peak integration by Apex track, especially low level response and for sensitivity
Only option as attached (if 0.2 increments correct using UV setting?)
this gives theoretical data points ?
Top right example displaying sample points (auto I believe) on another CDS and identifying small peak (algorithm as described in previous post)
I'm not fully understanding where vertical hashmarks are and use of increments
You can set this between 0.00 - 39354 ?